Behringer X32 - Configuring for a Full Service (with Band)

Page 16
3.2 CONFIGURING FOR A FULL SERVICE (WITH BAND)
To configure the board for a full service that includes a band you have two options – if the worship
team you are doing sound for has a pre-configured scene (we will be maintaining a list of scenes in
the soundboard binder) then it is a matter of loading that scene as a starting point and modifying it
as required.
In most cases you will start with the SBF Default scene and then configure the board as outlined in
this section.
Loading a scene is accomplished as outlined in Section 3.0 – please refer to that section to select and
activate the appropriate scene in the X32.
Now the board is configured to either a default scene, or a scene specifically customized to the
Worship Team (if one exists in the scene library). If you are using a specific scene for the worship
team, it may require some small tweaks which will be covered in the next few sections on configuring
channels.
When starting from the SBF Default scene, all of the band channels (CH 1-14) are un-configured with
the exception of the Piano, Kick, Snare and Bass channels which are ready for use if required. The
podium microphones, wireless microphone, Visual and Audio PC’s are already configured and ready
to use as for the Basic Service referenced in Section 3.0.
To switch back and forth between the BAND and SERVICE channels, you simply press the appropriate
button on the left side of the board – SERVICE (CH 17-32) or BAND (CH 1-16).
Figure 20 - SERVICE button active with default channels showing