Page 15
Once on the SCENES tab, you can then use the LOAD knob to highlight the SBF Default scene and
then press the LOAD knob to activate the scene (see Figure 18). You will be asked to confirm using
the right arrow button.
Figure 18 - Loading Scene into X32
Now the board is configured to a default starting point, with all channels muted, and only a basic
configuration that supports Pulpit Mic 1, Pulpit Mic 2, Wireless Microphone, the Presentation PC and
the Audio PC.
Press the button labelled SERVICE (CH 17-32) on the left hand side of the board and you will see
these preconfigured channels ready to use (see Figure 19).
Figure 19 - SERVICE button active with channels showing
To Next Page
Loading...
