Page 10
Make sure the monitor is OFF, check the settings on the back panel and reset the monitor to defaults
– See Section 9.1.
The electric guitarist is now configured with optional vocals. See the section on using the FX150
monitor and remind the musician how to use the monitor.
In this configuration:
INPUT 1 on the FX150 controls the monitor level
INPUT 2 on the FX150 controls the voice level (OPTIONAL)
AUX on the FX150 controls the guitar level (IF USING A GUITAR PROCESSOR)
The MASTER knob controls the overall level of the monitor
Figure 11 - Monitor Setup for Electric Guitarist
2.7 ACOUSTIC INSTRUMENTS (OPTIONAL VOCALS)
Other types of instruments that don’t directly plug in to the sound system including acoustic guitars
with no preamp, flutes, violins, etc. require the use of a microphone and it is not necessary to
provide any input into the monitors because the instrument can be heard on stage.
Place one of the FX150 monitors on a mic stand (if setting up for vocals), a music stand or on the
stage and run an XLR cable from one of the monitor feeds under a nearby stage plate to INPUT 1 on
the monitor. Now hook up the power supply to the monitor, and plug it in to an outlet under the
stage plate.
To Next Page
Loading...
