Page 27
5.0 FX150 MONITOR
5.1 CONFIGURING THE MONITOR
Make sure the monitor is OFF, and in order to reset to a clean configuration, depress and hold the
three LOW buttons on the front while turning the unit on, continuing to hold until the unit is
powered up. These monitors remember the settings used previously, and resetting gives you a clean
configuration to work from.
Figure 33 - Resetting the FX150 to Defaults
Now confirm that the Hi-Z, +48V and Full Mix/CH1 buttons are NOT DEPRESSED (in the out position).
Figure 34 - FX150 Rear Panel Settings
To Next Page
Loading...
