Behringer X32 - 5.7 Everything you ought to know about Solo and monitor sources

Page 26
4.5 ADDING FX
Occasionally you will want to add a touch of reverb or delay to the vocals in order to fill them out a
bit, setting FX level is quite similar to setting the monitor mix. Press the Bus 1-8 Button (labelled
Monitor/FX) and you will see two FX channels - identified as FX Reverb and FX Delay.
Figure 32 - FX Reverb and FX Delay
The FX Reverb and FX Delay fader controls the overall level of FX applied, and just like the monitors if
you press the SELECT button, and then press SENDS ON FADER, you can then adjust the amount of FX
for each channel on the left side of the board.
If you need to increase or decrease the overall FX level, use the FX fader, if you wish to add more FX
to only a specific channel, then use the SELECT button, press SENDS ON FADER and then adjust the
channel there.
Always remember to turn off the SENDS ON FADER button when you are done, so it stops flashing
and you get back to controlling your mix.