Page 1
1.0 SETTING UP THE SERVICE
To set up a basic service, the only configuration that is required on the stage is to connect microphones to
either or both of the inputs labelled Podium 1 and Podium 2 in the stage plate at the front of the stage (see
illustration below).
The wireless microphone, the Presentation PC, the Audio PC and the hearing loop are all pre-configured on
the sound board and require no setup.
Figure 1 - Basic Service Podium Connections
If you don’t have a band then you should proceed to Section 3.0 which details how to configure the sound
board. If you do have a band, continue on to Section 2.0 (the next section).
To Next Page
Loading...
