Behringer X32 - 5.4 How do I add one of the 8 internal effects to the sound?; 5.6 How do I set up live stage monitoring?

Page 25
4.4 THE MATRIX – SUB, MAINS AND BUILDING
Now that the board is all configured, the channels are assigned and labelled and the monitor mix is
set it is time to bring up the front of house volume and set the individual channels into the mix. The
board is set up to drive our front of house full range speakers, the ceiling mounted sub and the
building speakers. The volume levels for each of these can be set relative to each other by selecting
the MATRIX 1-6 MAIN C button near the center of the board, and you will see three channels labelled
Main, Sub and Building. Normally you will not need to touch these as we have preconfigured them
for the best all-around mix, but if you think you need to have a bit more oomph from the sub, you
can reduce the mains, or boost the sub if required.
Figure 31 - Matrix Section for Mains, Sub and Building
To the right side of this section is the main LR speaker fader that is the master volume for front of
house and building speakers.