GN-9371_2_3 User Manual
Page 75 of (110)
G-series GN-9371_2_3 PIO Rev. 1.02.docx
14 Breakpoints (GN-9372/GN-9373 only)
Breakpoints are commonly used for debugging programs. You can set breakpoints at specific positions in the program to
force an execution stop and to monitor variable values. You can also set data breakpoints to halt program execution when the
value of a specific variable changes. CODESYS supports breakpoints in all IEC editors. The halt at a breakpoint or data
breakpoint can be linked to additional conditions. You can also redefine breakpoints and data breakpoints as execution points
where specific code is executed instead of stopping the program.
(1) Select the desired line and press F9 to set the brake point. Start by pressing F5.
To Next Page
Loading...