BELL HELICOPTER 430 - 5-26. PROGRESSIVE INSPECTION - EVENT 11; DETAIL:; NOTE

BHT-430-MM-2
5-00-00
26 JAN 2007 Rev. 15 Page 71
SCHEDULED INSPECTIONS
5-26. PROGRESSIVE INSPECTION — EVENT 11
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
DATE: __________________W.O. ____________________
_
FACILITY: _________________________________________
_
HELICOPTER S/N: __________________________________
_
REGISTRY NO.: ____________________________________
_
TOTAL TIME:______________________________________
_
SIGNATURE:_______________________________________
_
GENERAL:
Paragraph 5-13 1. Do a complete 50 hour inspection.
DETAIL:
Chapter 67 and
BHT-ALL-SPM
1. Open the access panels in the tunnel behind the pilot
station. Examine the lower and upper cyclic and collective pitch
control bellcranks for loose bearings, corrosion or mechanical
damage to the clevises. Make sure they are correctly attached
to the supports and control tube bearings. (F5/F6)
Chapter 71 2. Examine the engine control cables and idle stop solenoids
for corrosion and damage. Make sure they are correctly
attached. (F5/F6)
NOTE
Examine inspection window(s) and sight glass(es)
for cracking and discoloration. If either of these
conditions are present the part must be removed and
replaced prior to returning helicopter for service.
Chapter 63 3. Examine the left and right pylon fluid mounts for corrosion,
damage and correct fluid level. Make sure they are correctly
attached. (F5/F6)
Chapter 63 and
BHT-430-CR&O-2
4. Examine the upper and lower lift link rod end bearings for
serviceability. (F5/F6)