BELL HELICOPTER 430 - 5-53. COMPONENT OVERHAUL SCHEDULE; WARNING; CAUTION; NOTE

BHT-430-MM-2
5-00-00
9 SEP 2011 Rev. 18 Page 153
ECCN EAR99
COMPONENT OVERHAUL SCHEDULE
5-53. COMPONENT OVERHAUL SCHEDULE
The Component Overhaul Schedule (Ta b le 5- 2 )
provides the time interval between overhaul for each
applicable helicopter component.
WARNING
DO NOT APPLY TOLERANCES TO
PARTS WITH A LIMITED
AIRWORTHINESS LIFE (CHAPTER 4).
WARNING
DO NOT EXCEED RETIREMENT LIFE
FOR CRITICAL COMPONENTS. REFER
TO AIRWORTHINESS LIMITATIONS
SCHEDULE (CHAPTER 4).
SOME PARTS INSTALLED AS ORIGINAL
EQUIPMENT ON MILITARY
HELICOPTERS MAY HAVE A LOWER
AIRWORTHINESS LIFE AND/OR
OVERHAUL SCHEDULE THAN WHEN
USED ON A COMMERCIAL
HELICOPTER. CONSEQUENTLY, PARTS
THAT HAVE BEEN USED ON MILITARY
HELICOPTERS SHOULD NOT BE USED
ON COMMERCIAL HELICOPTERS.
CAUTION
OVERHAUL SCHEDULE FOR SOME KIT
COMPONENTS AND/OR PARTS IS NOT
COVERED IN THIS SCHEDULE. REFER
TO APPLICABLE SERVICE
INSTRUCTIONS FOR KIT COMPONENTS
SCHEDULE.
NOTE
Refer to paragraph 5-6 for information on
inspection and overhaul tolerance.
NOTE
Neither assignment of a time period for
overhaul of a component or failure to
assign a time period for overhaul of a
component constitutes a warranty of any
kind. The only warranty applicable to
helicopter and any component is that
warranty included in the Purchase
Agreement for the helicopter or component.
The overhaul interval specified for any given part
number contained in this Component Overhaul
Schedule applies to all successive dash numbers for
that item unless otherwise specified.
Refer to the Rolls-Royce 250-C40B Operation and
Maintenance Manual, Publication CSP 21000 for the
time between overhaul for the power plant
components.
Table 5-2. Component Overhaul Schedule
NOMENCLATURE PART NUMBER OVERHAUL INTERVAL
ROTORS
Tail Rotor Hub Assembly 222-012-701-125 2500 hours
Swashplate and Support Assembly 430-010-400-101 5000 hours
1