BELL HELICOPTER 430 - 5-15. 600 HOUR;ANNUAL INSPECTION; DETAIL:

BHT-430-MM-2
5-00-00
26 JAN 2007 Rev. 15 Page 23
SCHEDULED INSPECTIONS
5-15. 600 HOUR/ANNUAL INSPECTION
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
DATE: __________________W.O. ____________________
_
FACILITY: _________________________________________
_
HELICOPTER S/N: __________________________________
_
REGISTRY NO.: ____________________________________
_
TOTAL TIME:______________________________________
_
SIGNATURE:_______________________________________
_
To be performed every 600 hours of operating time or a
minimum of once every 12 months, whichever comes first.
DETAIL:
1. Examine the contents of the first aid kit. Replace any
damaged or time expired items. Replace any items with
deteriorated packaging. (F2)
Chapter 12 and
Chapter 67
2. Remove the left, center and right bottom access panels
from below the crew compartment. Examine the control tubes,
links, rod end bearings, bellcranks, supports and attach bolts for
corrosion and wear. Make sure they are correctly attached.
Make sure the spring cartridges and rotary actuators are
correctly attached. (F1/F2)
Chapter 67 3. Measure the amount of minimum friction on the cyclic stick,
collective stick and the tail rotor pedals. Adjust the minimum
friction as necessary. (F2)
Chapter 12 4. Remove the access panels along the bottom centerline of
the fuselage. (F3/F4)
Chapter 67 a. Examine the directional control tubes, rod end bearings,
bellcranks, supports and attach bolts for corrosion and wear.
Make sure they are correctly attached.
b. Examine the wiring bundles for chafing. Make sure they
are correctly attached with clamps. Examine all of the exposed
structure for corrosion, distortion or cracks.