BELL HELICOPTER 430 - 5-34. EVERY 2500 HOURS OF COMPONENT OPERATION; MAIN ROTOR BLADES; NOTE; MAIN ROTOR YOKES

BHT-430-MM-2
5-00-00
26 JAN 2007 Rev. 15 Page 91
SCHEDULED INSPECTIONS
5-34. EVERY 2500 HOURS OF COMPONENT OPERATION
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
DATE: __________________W.O. ____________________
_
FACILITY: _________________________________________
_
HELICOPTER S/N: __________________________________
_
REGISTRY NO.: ____________________________________
_
TOTAL TIME:______________________________________
_
SIGNATURE:_______________________________________
_
MAIN ROTOR BLADES
Chapter 4
NOTE
Step 1 is an airworthiness inspection limitation.
1. Examine the main rotor blades as follows: (R1)
a. Remove the main rotor blades.
b. Clean the main rotor blades.
c. Do a visual inspection of the main rotor blades for
delamination and damage.
d. If any defect is found, contact Bell Helicopter Product
Support Engineering for instructions.
MAIN ROTOR YOKES
Chapter 4
NOTE
Step 1 is an airworthiness inspection limitation.
1. Examine the main rotor yokes as follows: (R1)
a. Clean the yokes.