BELL HELICOPTER 430 - 5-40. AFTER EVERY MAIN ROTOR BLADE REMOVAL; MAIN ROTOR YOKES; NOTE

BHT-430-MM-2
5-00-00
SPECIAL INSPECTIONS
5-40. AFTER EVERY MAIN ROTOR BLADE REMOVAL
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
DATE: __________________W.O. ____________________
_
FACILITY: _________________________________________
_
HELICOPTER S/N: __________________________________
_
REGISTRY NO.: ____________________________________
_
TOTAL TIME:______________________________________
_
SIGNATURE:_______________________________________
_
Chapter 4
NOTE
This is an airworthiness inspection limitation.
MAIN ROTOR YOKES
1. With the main rotor blades removed examine the main
rotor yokes as follows: (R1)
a. Clean the yokes.
b. Do a careful visual inspection of the yokes for cracks,
delamination and impact damage.
BHT-430-CR&O-2 c. If any defect is found, refer to BHT-430-CR&O-2
(Chapter 62) for damage criteria.
26 JAN 2007 Rev. 15 Page 105/106