BELL HELICOPTER 430 - 5-23. PROGRESSIVE INSPECTION - EVENT 8; GENERAL:; DETAIL:; NOTE

BHT-430-MM-2
5-00-00
26 JAN 2007 Rev. 15 Page 59
SCHEDULED INSPECTIONS
5-23. PROGRESSIVE INSPECTION — EVENT 8
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
DATE: __________________W.O. ____________________
_
FACILITY: _________________________________________
_
HELICOPTER S/N: __________________________________
_
REGISTRY NO.: ____________________________________
_
TOTAL TIME:______________________________________
_
SIGNATURE:_______________________________________
_
GENERAL:
Paragraph 5-13 1. Do a complete 50 hour inspection.
DETAIL:
NOTE
Examine inspection window(s) and sight glass(es)
for cracking and discoloration. If either of these
conditions are present the part must be removed and
replaced prior to returning helicopter for service.
Chapter 63 1. Examine the left and right pylon fluid mounts for corrosion,
damage and correct fluid level. Make sure they are correctly
attached. (F5/F6)
Chapter 63 and
BHT-430-CR&O-2
2. Examine the upper and lower lift link rod end bearings for
serviceability. (F5/F6)
NOTE
Examine inspection window(s) and sight glass(es)
for cracking and discoloration. If either of these
conditions are present the part must be removed and
replaced prior to returning helicopter for service.
Chapter 63 3. Examine the transmission for correct fluid level and leaks.
(F5/F6)