BHT-430-MM-2
5-00-00
Page 80 Rev. 19 1 NOV 2012
ECCN EAR99
This inspection is limited to yoke arm(s) that has
crack(s) greater than 3.0 inches (76.19 mm).
Main rotor blade must be removed to perform this
inspection.
BHT-430-CR&O-2,
Chapter 62
1. Examine the main rotor yokes as follows: (R1)
a. Clean the yoke(s).
b. Do a visual inspection of the yokes for cracks.
c. Refer to BHT-430-CR&O-2, Chapter 62 for damage
criteria.
5-28. EVERY 100 HOURS OF COMPONENT OPERATION (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
To Next Page
Loading...
