BHT-430-MM-2
5-00-00
c. Do a thorough visual inspection of the components that
follow. You may keep the components in service if you do not
find any damage.
(1) Swashplate and levers assembly.
(2) Drive hub, drive link and idler link assemblies.
(3) Tail rotor driveshafts, couplings and bearings.
d. 25 hours after an overtorque, do a thorough inspection
of the systems that follow:
(1) Main rotor yokes and blades.
(2) Pylon fluid mounts and lift links.
(3) Cabin roof at the transmission lift link fittings.
(4) Transmission restraint attachments.
(5) Transmission electric chip detectors.
(6) Tail rotor hub, blades and attachments.
(7) Swashplate and levers assembly.
(8) Drive hub, drive link and idler link assemblies.
(9) Tail rotor driveshafts, couplings and bearings.
CONDITIONAL INSPECTIONS
5-48. OVERTORQUE (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
26 JAN 2007 Rev. 15 Page 137/138
To Next Page
Loading...
