BHT-430-MM-2
5-00-00
Page 14 Rev. 15 26 JAN 2007
Chapter 25 4. Examine the safety belts and shoulder harnesses for
deterioration. Make sure they are correctly attached to the
airframe structure. (F1/F2/F3/F4)
Chapter 53 5. Examine the crew doors, passenger doors and baggage
compartment doors for damage or corrosion. Examine the
positive locking mechanisms. Examine the door seals for tears
or separations. Make sure the doors are correctly attached to
the airframe structure. (F1/F2/F3/F4)
Chapter 26 6. Examine the cabin fire extinguisher for damage or
corrosion. Examine the operation of the quick opening clamp.
Make sure the fire extinguisher is fully charged. (F1/F2)
Chapter 11 and
BHT-430-FM-1
7. Examine the placards and instrument panel decals. Make
sure all of the instrument markings are clear and legible. (F1/F2)
Chapter 53 8. Examine the condition of the electrical and avionics
components in the nose compartment. Make sure they are
correctly installed. Examine the electrical harnesses and cables
for frayed wires and loose or broken clamps and fasteners.
9. Examine the nose compartment door for damage. Make
sure it latches correctly. (F1/F2)
Chapter 95 10. Examine the pitot tubes. Make sure they are correctly
attached. (F1/F2)
Chapter 67 and
BHT-ALL-SPM
11. Examine the cyclic and collective shaft assemblies and
control tubes installed on the roof for loose bearings, wear,
corrosion or mechanical damage. Make sure they are correctly
attached. (F5/F6)
SCHEDULED INSPECTIONS
5-14. 150 HOUR INSPECTION (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
To Next Page
Loading...
