BHT-430-MM-2
5-00-00
26 JAN 2007 Rev. 15 Page 17
NOTE
Examine inspection window(s) and sight glass(es)
for cracking and discoloration. If either of these
conditions are present the part must be removed and
replaced prior to returning helicopter for service.
Chapter 12 and
Chapter 79
25. Examine the left and right engine oil tanks for correct fluid
level and leaks. Examine all oil lines for leaks. (F5/F6)
NOTE
Examine inspection window(s) and sight glass(es)
for cracking and discoloration. If either of these
conditions are present the part must be removed and
replaced prior to returning helicopter for service.
Chapter 63 26. Examine the left and right pylon fluid mount assemblies for
corrosion, damage and correct fluid level indication. Make sure
they are correctly attached. (F5/F6)
Chapter 63 and
BHT-430-CR&O-2
27. Examine the upper and lower lift link rod end bearings for
serviceability. (F5/F6)
Chapter 63 28. Examine the left longitudinal restraint spring and support
for damage. Make sure they are correctly attached. (F5)
Chapter 63 29. Examine the right longitudinal restraint spring and the
lateral restraint spring and support for damage. Make sure they
are correctly attached. (F6)
CAUTION
THE INGESTION OF BROKEN INLET SCREEN
SEGMENTS CAN CAUSE FOREIGN OBJECT
DAMAGE TO THE ENGINE COMPRESSOR
SECTION.
Chapter 71 30. If installed, examine both of the engine inlet screens for
damage. (F5/F6)
SCHEDULED INSPECTIONS
5-14. 150 HOUR INSPECTION (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
To Next Page
Loading...
