Operation and setting
45
IRDH275BM-7_D00123_06_M_XXEN/07.2018
5.6 Menu COM SETUP: Setting the BMS interface
5.6.1 Bus address „Addr:“
This menu item is used to set the BMS bus address of the ISOMETER®. Since
there are several ISOMETERs in one system, take care that the bus address is
not assigned twice.
The device is factory set to address 3 and hence acts as a slave.
If several ISOMETER®s are operated on one BMS bus, the
addresses of other ISOMETER®s must be assigned one after
the other, since only one device may represent the Master.
To Next Page
Loading...
