Bender COMTRAXX COM465IP - Inspection, Transport, and Storage; Warranty and Liability; Device Disposal

Important information
10
COM465IP-COM465DP_D00216_02_M_XXEN/03.2017
1.5 Inspection, transport and storage
Inspect the dispatch and equipment packaging for damage, and compare the contents of the pack-
age with the delivery documents. In the event of damage in transit, please contact Bender immedi-
ately.
The devices must only be stored in areas where they are protected from dust, damp, and spray and
dripping water, and in which the specified storage temperatures can be ensured.
1.6 Warranty and liability
Warranty and liability claims in the event of injury to persons or damage to property are excluded if
they can be attributed to one or more of the following causes:
 Improper use of the device.
 Incorrect mounting, commissioning, operation and maintenance of the device.
 Failure to observe the instructions in this operating manual regarding transport, commission-
ing, operation and maintenance of the device.
 Unauthorised changes to the device made by parties other than the manufacturer.
 Non-observance of technical data.
 Repairs carried out incorrectly and the use of replacement parts or accessories not approved by
the manufacturer.
 Catastrophes caused by external influences and force majeure.
 Mounting and installation with device combinations not recommended by the manufacturer.
This operating manual, especially the safety instructions, must be observed by all personnel working
on the device. Furthermore, the rules and regulations that apply for accident prevention at the place
of use must be observed.
1.7 Disposal
Abide by the national regulations and laws governing the disposal of this device. Ask your supplier
if you are not sure how to dispose of the old equipment.
The directive on waste electrical and electronic equipment (WEEE directive) and the directive on the
restriction of certain hazardous substances in electrical and electronic equipment (RoHS directive)
apply in the European Community. In Germany, these policies are implemented through the "Elec-
trical and Electronic Equipment Act" (ElektroG). According to this law, the following applies:
 Electrical and electronic equipment are not to be placed in household waste.
 Batteries and accumulators are not to be placed in household waste but must be disposed of in
accordance with the regulations.
 Old electrical and electronic equipment from users other than private households which was
introduced to the market after 13 August 2005 must be taken back by the manufacturer and
disposed of properly.
For more information on the disposal of Bender devices, refer to our homepage at www.bender-
de.com -> Service & support.