7
COM465IP-COM465DP_D00216_02_M_XXEN/03.2017
1. Important information
1.1 How to use this manual
This manual describes
The condition monitor with an integrated gateway COMTRAXX® COM465IP and
The condition monitor with an integrated gateway COMTRAXX® COM465DP
Before using the devices please read:
This manual. It describes
– the properties of the gateways COMTRAXX® COM465IP and COMTRAXX® COM465DP,
– the connection of the devices
– and the PROFIBUS DP interface of the COMTRAXX® COM465DP.
The "COMTRAXX" manual. It describes the functions of the web user interface for Bender
gateways.
The sheet "Important safety instructions for BENDER products".
The manuals for the system components.
As well as, if the related interface is used:
The "BCOM" manual. It describes the new Bender interface.
The "BMS bus" package slip.
COMTRAXX® COM465IP is also referred to in this manual as "COM465IP" for short.
COMTRAXX® COM465DP is also referred to in this manual as "COM465DP" for short.
The devices are called "COM465…" or "gateway" in texts that apply to both.
COMTRAXX® is registered trademark of Bender GmbH & Co. KG.
Terms used
This manual explains Bender-specific terms and functions in detail. Familiarisation with general spe-
cialist IT and network terminology is considered a prerequisite. These terms are therefore only ex-
plained briefly in this manual. You will find more detailed explanations in the related specialist
literature and in the Internet.
BCOM protocol for the communication between Bender devices via an IP-based network
BMS Bender measuring device interface (RS-485 interface with BMS protocol)
Always keep this manual within easy reach for future reference.
This manual is intended for qualified personnel working in electrical engineer-
ing and electronics.
To Next Page
Loading...