Installation, connection and commissioning
24
COM465IP-COM465DP_D00216_02_M_XXEN/03.2017
4.7.1 Addresses and their factory settings
The COM465… is supplied with the following factory settings:
The settings can be changed using the web user interface.
4.7.2 Installing GSD file for PROFIBUS DP master (COM465DP only)
A PROFIBUS DP master requires the device master data (Geräte-Stamm-Daten - GSD) for its slave
components distributed in the automation system. Accordingly, you must install the GSD file on the
master. It describes in a standardised format the properties of the COM465DP. You can obtain the
latest GSD file at:
http://www.bender.de > Service & support > Download > Software
1. Select the destination folder to which the GSD file is to be copied. For the exact destination
please see the documentation for the program you want to use to program the PROFIBUS mas-
ter.
2. Also copy the file BEND0F27.gsd to the folder created for the device master data.
Parameter Factory setting
IP address 192.168.0.254
Connection can always be made using the pre-defined IP
address
(e.g. for commissioning)
169.254.0.1
Net mask 255.255.0.0
Standard gateway 192.168.0.1
DNS 194.25.2.129
DHCP off
t
off
Timeout for DCHP address assignment
30 s
BMS address 1
BMS protocol BMS i
BCOM system name SYSTEM
Subsystem address 1
BCOM device address 1
PROFIBUS DP address 3
To Next Page
Loading...