Installation, connection and commissioning
20
COM465IP-COM465DP_D00216_02_M_XXEN/03.2017
4.2 Installation and connection
4.3 Installing device
The device is suitable for the following types of installation:
Snap-on mounting on a DIN rail according to IEC 60715 or
Screw mounting using 2 x M4
4.3.1 Outline drawing
COM465… is in a series J460 enclosure.
Only qualified personnel are permitted to carry out the work necessary to in-
stall, commission and run a device or system.
Mortal danger due to electric shock!
Touching live parts of the system carries the risk of:
An electric shock
Damage to the electrical installation
Destruction of the device
Before installing the device and prior to working on the device connections,
make sure that the installation has been de-energised. Observe the rules for
working on electrical installations.
Mortal danger and risk of irreparable damage due to moisture!
? Install device such that it is protected against moisture.
Pay attention to installation location
On installing the device, please take into consideration that the device is only to
be used in locations that are protected from unauthorised entry! This can be in-
stallation in a switch cabinet, for example.
107,5
40
62
33
45
14,4 11
62,9
93
To Next Page
Loading...