EasyManua.ls Logo

Bender COMTRAXX COM465IP - Example: IRDH375 Device Fault Query

Bender COMTRAXX COM465IP
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PROFIBUS DP (COM465DP only)
35
COM465IP-COM465DP_D00216_02_M_XXEN/03.2017
5.2.1.3 Example 3: Querying IRDH375 device fault
The IRDH375 has the BMS address 3, channel 4 is queried.
There is an "earth connection" device fault.
Request to the gateway
For an explanation of the protocol structure see "Type 1: Querying measured data from devices on
the bus" on page 27.
Byte 0 Byte 1 Byte 2 Byte 3 Byte 4 Byte 5 Byte 6 Byte 7 Byte 8 Byte 9
Byte 10
ID
Msg
type
System Device Channel 0x00 0x00 0x00 0x00 0x00 0x00
0x03 0x01 0x02 0x03 0x04 0x00 0x00 0x00 0x00 0x00 0x00
Byte 0: Sequential ID no.
Byte 1: Message type: For this request always 0x01
Byte 2: Subsystem address: 2
Byte 3: BMS device address: 3
Byte 4: Channel: 4
Byte 5-10: Always 0x00

Table of Contents

Other manuals for Bender COMTRAXX COM465IP