11
COM465IP-COM465DP_D00216_02_M_XXEN/03.2017
2. Safety instructions
2.1 General safety instructions
Part of the device documentation in addition to this manual is the enclosed "Safety instructions for
Bender products".
2.2 Work on electrical installations
If the device is used in a location outside the Federal Republic of Germany, the applicable local stand-
ards and regulations must be observed. European standard EN 50110 can be used as a guide.
2.3 Intended use
The gateway connects the following devices to Ethernet TCP/IP and PROFIBUS DP networks:
Bender devices with BMS bus or BCOM interface
Bender universal measuring devices PEM… with Modbus RTU or Modbus TCP.
The COM465… converts alarms, measured values and statuses from the devices to the Modbus TCP
and HTTP protocols. This conversion permits coupling to Modbus TCP networks as well as data dis-
play and evaluation using standard web browsers.
COM465DP only: The gateway transfers information from the BMS bus and BCOM interface to the
PROFIBUS DP and vice versa.
It is operated and configured using the web user interface integrated into the device.
Only qualified personnel are permitted to carry out the work necessary to in-
stall, commission and run a device or system.
Mortal danger due to electric shock!
Touching live parts of the system carries the risk of:
An electric shock
Damage to the electrical installation
Destruction of the device
Before installing and connecting the device, make sure that the installation
has been de-energised. Observe the rules for working on electrical installa-
tions.
To Next Page
Loading...