BENDIX TABS-6 - Diagnostic Trouble Codes (DTCs) - Reference (Continued); DTCs for Lateral Acceleration Sensor Signal

15
Diagnostic Trouble Codes (DTCs) (continued)
1st
Digit
2nd
Digit
Diagnostic Code
Description
Possible Causes / Repair Information
J1587
(SID/
FMI)
J1939
(SPN/
FMI)
8 2
LateralAcceleration
Sensor-SignalOut
OfRange
• Before troubleshooting, verify that the trailer has been parked on
level ground.
• Verify that the TABS‑6 Adv MC module has been mounted as per the
Installation Guidelines.
•PerformaLateralAccelerationSensor(installationangle)Component
Test using the Bendix
®
ACom
®
diagnosticsoftware(version6.1or
higher), and verify that the roll angle of the TABS‑6 Adv MC module
iswithin±5°asmeasuredfromaathorizontalplane.
• After repairs — or if no issues are found — clear the diagnostic code.
• If the diagnostic code persists, contact your local Bendix
representative before replacing the TABS‑6 Adv MC module.
099/14 1809/14
8 3
InternalLateral
Acceleration Sensor
-OffsetError
• Before troubleshooting, verify that the trailer has been parked on
level ground.
• Verify that the TABS‑6 Adv MC module has been mounted as per the
Installation Guidelines.
•PerformaLateralAccelerationSensor(installationangle)Component
Test using the Bendix
®
ACom
®
diagnosticsoftware(version6.1or
higher).
VerifytherollangleoftheTABS-6AdvMCmoduleiswithin±5°as
measuredfromaathorizontalplane.
Iftherollangleisoutoftolerance,clearthediagnosticcodeand
test drive the vehicle.
• After repairs — or if no issues are found — clear the diagnostic code.
• If the diagnostic code persists, contact your local Bendix
representative before replacing the TABS‑6 Adv MC module.
099/02 1809/02
8 4
LateralAcceleration
Sensor ‑ Sensor
SignalNotFound
• Verify that the TABS‑6 Adv MC module has been mounted as per the
Installation Guidelines:
TABS-6AdvMCmodulemountedeitherin0°or180°orientation.
•IftheECUhasbeenconguredforanexternallateralacceleration
sensor:
Checkforcorroded/damagedwiringorconnectorsbetweenthe
ECUandtheexternallateralaccelerationsensor.
VerifycorrectwiringbetweentheECUandtheexternallateral
acceleration sensor.
099/14 1809/14
8 5
ExternalLateral
Acceleration Sensor
SignalNotAvailable
•Checkforcorroded/damagedwiringorconnectorsbetweentheECU
and the external lateral acceleration sensor.
•VerifycorrectwiringbetweentheECUandtheexternallateral
acceleration sensor.
• After repairs — or if no issues are found — clear the diagnostic code.
• If the diagnostic code persists, contact your local Bendix
representative before replacing the Bendix
®
TABS‑6
™
Adv MC
module.
099/14 1809/14