Benelli TRK 502 User Manual

TRK 502/ 502X
30
For driving a new motorcycle in its rst 1,000km way, the engine should not be over revved and all the gears shall
not be over 80% of red zone engine rpm; don't operate the throttle under a fully open position; change the gears
in time to keep the engine rpm in reasonable range. It is strongly suggested to use the motorcycle very carefully
during its running in period; also the rider has to be familiar to the performance.
Note：In the rst 300km of break in, you should examine the cleanliness of the engine oil frequently. Check the
oil level of engine oil before driving.
INSPECTION BEFORE DRIVING
Please check on the following contents which are very important before driving,
RUNNING IN
Content
Handlebar
Braking
Comments
1) Stable
2) Turn smoothly
3) No sliding or loose
1）Right clearance of the lever and brake pedal
2）No sponge feeling

Benelli TRK 502 Specifications

General

Displacement	500 cc
Transmission	6-speed
Fuel Tank Capacity	20 liters
Seat Height	800 mm
Wet Weight	235 kg
Bore x Stroke	69 mm x 66.8 mm
Compression Ratio	11.5:1
Clutch	Wet multi-plate
Frame	Steel trellis
Wheelbase	1505 mm
Ground Clearance	190 mm
Max Power	47.6 hp (35 kW) @ 8500 rpm
Max Torque	46 Nm @ 6000 rpm
Front Suspension	50 mm upside-down fork
Front Brake	Double floating discs, 320mm, 4-piston calipers
Rear Brake	Single 260 mm disc
Fuel System	Electronic Fuel Injection (EFI)
ABS	Dual-channel ABS
Front Tire	120/70 R17
Rear Tire	160/60 R17
Engine Type	Liquid-cooled, four-stroke, parallel twin cylinder, DOHC, 4 valves per cylinder