7.6 Radiator/Reserve Bottle Assembly
7.6.1 Disassembly
Remove the body guard.
②
Remove the headlamp.
Loosen four fixing bolts for the radiator assembly.
Loosen the hose clamps for the inlet/outlet hoses of
the radiator.
Remove the power cord of the cooling fan.
Remove the radiator assembly and the reserve
bottle assembly.
7.6.2 Check
Open the reserve bottle cover and check the
coolant level inside.
Add coolant when it approaches the lower limit.
Broken or twisted heat sinks will reduce the
cooling capability of the radiator.
Repair the radiator with a small screwdriver
when over 1/3 of heat sinks are damaged or
twisted.
Replacement
Check the liquid level of the radiator.
Remove the radiator cover after the liquid
has fully cooled;
Completely remove the coolant;
Add the prepared coolant slowly through the
filling hole (thru radiator cap) until it reaches
the edge of the hole;
Install the radiator cap.
Note: please use 50/50 ethylene
glycol antifreeze and water;
①
②
③
①：edge ②：heat sink ③：coolant
The minimum temperature for using coolant is -31F
To Next Page
Loading...
