Bennett 3000 Spec 300 Series Instruction Manual Preliminary Install Information
19
STEP 1 - DETERMINE THE MODEL NUMBER
Identifying the features of the unit prior to installation will provide an understanding of how to perform an accurate installation. Follow
the steps below to determine what type of 3000 Series Electronic Dispenser you are installing.
DIN numbers are used to identify what type of dispenser or pump is being used and options used. Determine the model number of the
dispenser from the serial label located on Side 1 of the dispenser. Use the charts below to determine the features of the dispenser to be
installed. Note: The letter X denotes options not identified.
EXAMPLE:
3 X X X S N R – X X X X 2
3000 SERIES ELECTRONIC STANDARD SPEC 300
7 = Commercial Electronic
8 = Retail Electronics (1-Tier Pricing)
9 = Retail Electronics (2-Tier Pricing)
R = Remote
S = Suction
P = Suction with Prepay Valve(s)
1 = One Side
2 = Two Sides and 4 Hose Quads
4 = 4 Hose Active 4 Units
3000 SERIES ELECTRONIC BIG FUELER SPEC 300
7 = Commercial Electronic
8 = Retail Electronics (1-Tier Pricing)
9 = Retail Electronics (2-Tier Pricing)
1 or 2 for Side Mount Nozzle Boots
1, 2, or 4 for Front Mount Nozzle Boots
Remote Dispensers
M = Master
S = Satellite
C = Combo
D = Combo with Satellite In Use Light
L = Master with In Use Light
Suction Pumps
M = Master
L = Master with In Use Light
R = Remote (60 gpm)
S = Suction (40 gpm)
To Next Page
Loading...
