Bennett 3000 Series - SECTION 1: SAFETY INFORMATION

Bennett 3000 Series Spec 300 Instruction Manual Safety Information
1
SECTION 1: SAFETY INFORMATION
For safe installation of this equipment, read and understand all dangers, warnings, and cautionary information. Save this safety
information in a readily accessible location. Look for the following warnings throughout the manual:
Red and White “DANGER” means: If you do not follow the instructions, severe injury or death will occur.
Orange and Black “WARNING” means: If you do not follow the instructions, severe injury or death can occur.
Yellow and Black “CAUTION” means: If you do not follow the instructions, damage can occur to the dispenser.
Blue and White “IMPORTANT” means: helpful tips and other recommendations on equipment installation, usage, and
maintenance should be observed.
DANGER PELIGRO DANGER
 FIRE, EXPLOSION, INJURY, OR DEATH WILL OCCUR IF FUEL FILTERS ARE CHANGED BY UNTRAINED PERSONNEL. MAKE
SURE, ONLY TRAINED PERSONNEL CHANGE FILTERS.
 TO PREVENT INJURY TO YOU FROM VEHICLES AND ONLOOKERS, ALWAYS PLACE A BARRIER AROUND THIS EQUIPMENT
BEFORE PERFORMING SERVICE OR MAINTENANCE.
 GASOLINE AND FUEL ETHANOL IS FLAMMABLE. NO SMOKING OR OPEN FLAME.
 FUEL ETHANOL IS POISONOUS AND SHOULD NOT BE INGESTED.
 DENATURED ETHANOL FOR BLENDING E85 OR OTHER ETHANOL BLENDS SHOULD NOT BE STORED DUE TO THE RISK OF
EXPLOSION.
 DISCONNECT ALL POWER, RELIEVE PRESSURE TO THIS EQUIPMENT, AND ASSOCIATED COMPRESSOR DURING
INSTALLATION, SERVICE, OR ANY MAINTENANCE I.E., CHANGING FILTERS.
WARNING ADVERTENCIA MISE EN GARDE
 You must have training in the installation, service, or maintenance of this equipment (dispenser, pump, console, control
box, or submerged pump) before working on it. Maintenance repairs must be done by authorized personnel only.
Warranty work may only be performed by Bennett certified technicians.
 To prevent electric shock, keep the electrical parts of the dispenser dry.
 Electronic components are static sensitive. Use only proper static precautions (e.g. static straps) before working on the
equipment.
 The emergency shut-off valve (also called the fire valve, shear valve, or impact valve) must be closed when service or
maintenance is performed on this equipment.
 You must have training in the operation and programming of this dispenser before using it. READ THE OPERATORS
MANUAL.
 Make sure this equipment is correctly grounded. Failure to do will cause injury or damage equipment or improper
operation. Improper grounding voids the warranty.
 When anchoring the dispenser, always level the dispenser with shims before bolting to the island. DO NOT shim the
middle of base rails to bolt down the dispenser.
CAUTION PRECAUCIÓN MISE EN GARDE
 Do not drill holes in fuel dispensers. Holes can cause failure of the electronic equipment. THE WARRANTY WILL BECOME
VOID. Use only adhesive backed sign mounting brackets.
IMPORTANT IMPORTANTE IMPORTANT
 All trained technicians must work in accordance to all requirements, standards, and guidelines specified by the suppliers
Environmental Standards® Health, Safety, Security & Environment (HSSE) policies. Note: Bennett Pump highly
recommends all technicians observe HSSE policies defined by the supplier. Bennett Pump does not impose any restrictions
or additional requirements contained in Environmental Standards® Health, Safety, Security & Environment (HSSE) policies.
!! READ AND UNDERSTAND ALL WARNING LABELS ATTACHED TO THE DISPENSER !!