Bernard Controls AQ Logic Series - Page 39

English
39
5.9.2 Set Input signal
How to set Input Signal
1. From Analog Input/Output menu, enter Input Signal Type.
The Input Signal type screen appears.
2. For Signal Type and Signal Direction settings:
a. Select the setting to adjust and validate with OK.
The corresponding setting screen appears.
b. Select the desired value and validate with OK.
c. Continue button is highlighted, validate with OK.
d. The display goes back to Input signal type screen.
3. Go to Save then validate with OK.
The Input Signal Type confirmation screen appears.
4. Select YES then validate with OK.
You go back to Analog Input/Output menu.