Bernard Controls AQ Logic Series - Set Forced Local Mode in Remote Mode

English
45
5.11 Setting Forced local mode in Remote mode
You need 2 steps to be able to use Forced local mode:
1. Allowing switch to Local mode with Local control
2. Switch to Local mode with App
5.11.1 Allowing / Inhibit switch to Local control
How to allow or inhibit switch to Local control
1. Enter the menu with Access code to Read and Write
2. Go to Settings > Actuator’s access codes >
The Actuator’s access codes screen appears.
Go down in the menu to Switch Local/Remote Mode.
3. Validate with OK. The Switch Local/Remote Mode screen
appears.
4. To allow switch to Local control, select Switch to Local mode
allowed else select Switch to Local mode inhibited, then
validate with OK.