Bernette B05 Crafter - Triple Zigzag Stitch; Super-Stretch Stitch; Sewn-out Zigzag Stitch

Practical stitches
45
2020-09 EN 5220105.00A.04
4.6 Sewing Triple zigzag
The triple zigzag is particularly suitable for firm fabrics, especially denim, deckchair fabric and awnings, and
for hems on fabrics that are washed often.
Prerequisite:
• Finish the seam edges first.
> Fit the zigzag foot.
> Set the stitch length selector knob to «S1».
> Turn the stitch selector knob to category «B».
> Set the required stitch width.
4.7 Super-stretch
The super-stretch stitch is a narrow stretch stitch designed to eliminate puckering on knit fabrics and bias
seams, while permitting the seam to be pressed completely open flat.
> Fit the zigzag foot.
> Set the stitch pattern selector knob to «L».
> Set the stitch length and stitch width according to the stitch table.
> Sew the seam at the required distance from the fabric edge without stretching the fabric.
4.8 Sewn-out Zig zag
The sewn zigzag is used to finish seams on synthetics and other fabrics that tend to pucker. The stitch is also
excellent for darning and mending tears, as well as for attaching elastic tape.
> Fit the zigzag foot.
> Set the stitch pattern selector knob to «C».
> Set the stitch length and stitch width according to the stitch table.
For finishing:
> Position the fabric so that the stitch is sewn at a distance of 1.5cm from the edge of the fabric.
> Sew the seam.
> Trim the seam allowance after sewing. Be careful not to cut the stitches.
For sewing on elastic tape:
> Pin the elastic tape to the left-hand side of the fabric. When doing so, stretch the tape and ensure that it
is positioned evenly on the fabric.