Practical stitches
48
2020-09 EN 5220105.00A.04
> Guide the edge of the fabric into the center of the zigzag foot so that the needle goes into the fabric on
one side and over the edge into the air on the other side.
> Guide the edge of the fabric along the guide plate on the overlock foot (1) so that the needle goes into
the fabric on one side and over the edge into the air on the other side.
4.11 Sewing Double overlock
A double overlock seam is suitable for looser knit fabric and for cross seams in woven fabric. A new jersey or
stretch needle must be used for knit fabrics so that the delicate knit is not damaged.
> Fit the zigzag foot or overlock foot.
> Set the stitch pattern selector knob to «F».
> Set the stitch length knob to «S1».
> Set the stitch width according to the stitch table.
> For finishing the edge of the fabric with the zigzag foot: Position the edge of the fabric under the presser
foot so that the right-hand straight stitch is sewn close to the edge of the fabric.
> For sewing and hemming elastic fabrics and for sewing belt loops: Fold the edge of the fabric backwards
with the left-hand sides together. Sew the seam on the right-hand side of the fabric. Cut off any excess
fabric from the edge of the fabric up to the seam.
4.12 Sewing Vari overlock
> Fit the overlock foot.
> Set the stitch pattern selector knob to «D».
> Set the stitch length and stitch width according to the stitch table.
To Next Page
Loading...
