Quilting
65
2020-09 EN 5220105.00A.04
With stipple quilting, entire surfaces of the fabric are filled with quilt stitches. The single lines of stitching are
rounded and never cross one another.
Prerequisite:
• The top layer, the batting and the backing are pinned together or basted.
> Lower the feed dog.
> Remove the presser foot holder and fit the freehand embroidery foot or darning/embroidery foot on the
presser foot bar.
– The lever (1) must rest on the top of the needle clamping screw (2).
> Press the freehand embroidery foot or darning/embroidery foot from underneath with your finger and
tighten the screw (3).
> Set the stitch length to «0».
> Set the stitch pattern selector knob to «A».
> If required, adjust the upper thread tension for the sewing project.
> Press the foot control to start the machine.
> Hold both hands close to the presser foot like an embroidery hoop to guide the fabric.
> If the thread is lying on the top, continue sewing at a slower pace.
> If knots form on the wrong side of the fabric, guide the fabric more quickly.
7.4 Sewing patchwork
Sewing patchwork parts together
> Fit the zigzag foot or patchwork foot.
> Set the stitch pattern selector knob to «A».
> Set the stitch length knob to the required stitch length of 1–3.
> Set the needle position to «Center».
> Place the two parts with the right sides together.
To Next Page
Loading...
