Bernette B05 Crafter - Shell Edging with Satin Stitch

Decorative stitches
58
2020-09 EN 5220105.00A.04
> Set the stitch pattern selector knob to «H».
> Set the required stitch length.
> Set the required stitch width.
> Fold the edge of the fabric in by about 5mm. Position the fabric under the presser foot so that the
needle goes into the air just past the edge of the fabric on the right-hand side.
Shell edging with satin stitch
A wavy hem with satin stitches can be used to decorate blouse necklines and the edges of knitted fabrics.
> Fit the zigzag foot.
> Turn the stitch pattern selector knob to position «K».
> Select the required stitch length.
> Set the required stitch width.
> Set the needle position to «Center».
> Sew along the edge of the fabric at a distance of approx. 1cm.
> Use scissors to cut the fabric carefully along the seam.