15
Sewing preparation
Inserting a bobbin/Threading lower thread
█
insert the bobbin so that the thread runs clockwise A
█
pull the thread from the right into the slot
Exchanging bobbin case
Removing the bobbin case
█
raise the needle
█
turn power switch to «0» (off)
█
open bobbin cover
█
grasp the latch of the bobbin case
█
remove the bobbin case
Bobbin thread cutter
█
pull the thread over thread cutter A to cut it
█
close the cover
Inserting the bobbin case
█
hold the bobbin case latch
Opening of the bobbin case points up.
█
insert the case so that it clicks into place
A
A
█
pull the thread to the left under the spring
█
until it lies in the T-shaped slit at the end of the spring
█
pull the thread
►
the bobbin must turn clockwise
To Next Page
Loading...
