16
Sewing preparation
Threading the upper thread
█
raise the needle and presser foot
█
turn power switch to «0» (off)
█
place foam pad on the spool pin
█
place spool on pin so that the thread unwinds clockwise
█
attach appropriate spool disc
B
A
C
E
F
D
Removing the needle
█
raise the needle
█
lower or remove presser foot (see page 18)
█
turn power switch to «0» (off)
█
loosen the needle clamp screw
█
pull the needle down to remove
Inserting the needle
█
flat side of needle to the back
█
insert the needle as far as it will go
█
tighten needle clamp screw
Changing the needle
Appropriate spool disc
Diameter of thread spool determines disc size. There must be no
gap between the disc and the spool.
█
take thread through rear guide A
█
then into slit of upper thread tension B
█
pull thread down to the right of the take-up cover and around C
█
take thread up to the left of the cover and around D, placing it in the
take-up lever
█
take thread down and through guides E and F
█
thread the needle (see page 18)
C
E
F
To Next Page
