Needle Inserter
Needle Threader
Needle pad
To handle the needle conveniently use the Needle Threader /
-Inserter which is provided in the Accesssories Storage.
⦁
Sliding the Needle Inserter over the needle before loosening
the set screw avoids dropping the needle.
⦁
The new needle is held in place by the Needle Inserter while
inserting and tightening the screw.
In the convenient needle pad you can store needles temporarily if
only one of them is used or if special needles are inserted.
Threading the needle
A Metal rod in Y-shaped threader
B Hold the needle threader with the triangle shaped mark
upwards and guide the thread horizontally through the
Y-shaped slot.
C While gently pulling the thread end, push the nose of the nee-
dle threader onto the needle shaft and start sliding down.
Please Note: Push the Threader only gently towards the nee-
dle in order not to damage the metal rod.
D When having reached the needle eye, push, so that the metal
rod slides through the eye, taking along the thread.
E By slowly retracting the needle threader, a thread loop will be
left behind the needle.
F Pull the thread end completely through the eye and place the
thread end under the presser foot.
BA
C D
E F
To Next Page
Loading...
