Bernina L460 - Sewing Examples; Securing a Seam; Seam Begin; Seam End

L 450
L 460
33
1 Wrong side of the fabric
2 Right side of the fabric
3 Upper looper thread
4 Lower looper thread
5 Left needle thread
6 Right needle thread
Seam end
⦁
Sew to the end of the seam.
⦁
Raise the needles.
⦁
Raise the presser foot.
⦁
Pull the work carefully towards the back.
⦁
Turn the seam over and lay it under the presser foot (3) so that
the needles enter the fabric with the first stitch.
⦁
Lower the presser foot.
⦁
Sew carefully over the previous stitches (without cutting) for
about 2-3cm/1.5".
⦁
Turn the work to the left and sew an additional thread chain
(not in fabric). (4)
⦁
Pull the thread chain from the back over the thread cutter (5).
Threading and Sewing
Securing a Seam
Seam begin
Sewing examples
⦁
Sew to form a 4cm/1.5" chain (1).
⦁
Position the fabric and sew one stitch.
⦁
Bring the needles down.
⦁
Raise the presser foot.
⦁
Pull the thread chain gently to the left and place it in front under
the presser foot.
⦁
Lower the presser foot.
⦁
Sew over the thread chain (2).
⦁
After approx. 2cm/1", cut off the excess.
L 460
⦁
Adjust the up/down position of the needle by sinking
the heel back on the foot control.
12
3
5
4