1
3
3
4
4
5
6
8
7
2
1
6
7
8
Threading the upper looper (blue)
1
1
2
3
3
5
4
4
6
6
8
8
7
7
4-/3-thread overlock (Stitch No. 1, 3-8, 30)
⦁
Prepare maschine for threading.
„Threading - General information“ see
page 24.
⦁
Make sure that the handwheel is in
threading position (Handwheel position
indicator window) (1) and the presser
foot is lifted.
⦁
Feed the thread from the back through
the thread guides (2).
⦁
Thread through the pretension(3).
⦁
Pull the thread through the thread ten-
sion (4).
⦁
Insert the thread into the thread guides
(5) and (6).
⦁
Pass the thread through the wire thread
guide on top of the upper looper (7) and
then through the upper looper eye (8).
⦁
Pull about 10 cm/ 4" of thread to the
back and place it under the presser
foot.
The thread tension is released
when the presser foot is lifted.
To Next Page
Loading...
