56
MAINTENANCE
GENERAL RULES
Regular maintenance is extremely important
for ensuring the best performance and long-
life of the motorcultivator.
It is thus advisable to:
- periodically clean the motorcultivator,
spraying it with water to remove dust, mud
and dirt.
- at the end of each day spray the inside of
the hoe with water to remove any mud or
dirt built-up.
- when the machine is used as a mower,
clean the entire cutting unit at the end of
each day in order to remove any accumulated
grass or dirt, lubricate the unit with grease
or fuel oil.
- carry out the schedule of checks and
lubrications described below.
Periodically use oil to lubricate rods, hinges, cable passages and all points subject to
movement that are accessible from the outside.
CONTROL AND LUBRICATION PROGRAM
See engine Use and Maintenance Manual
Position
Period
Daily
Every 10
hours
First 20
hours
Every 500
hours
Check level Check Change
Check collector and brushes once a year
Check tyre pressure periodically
Engine oil
Air filter
Gearbox oil
Battery fluid
Starter motor
Tyres
Rotary hoe box oil
Control level
AIRBORNE NOISE
Acoustic pressure recorded at 1,6 m off the
ground in the centre of the handlebars by a B
& K 2230 instrument facing the engine.
Maximum level of acoustic pressure sta-
tistically weighted equivalent.
- Motorcultivator: 88,3 dB (A)
- Mower: 90,7 dB (A)
Sound Power:
- Motorcultivator: 104,6 dB (A)
- Mower: 104,6 dB (A)
HANDLEBAR VIBRATION
Statistically weighed measurement in accor-
dance with ISO 5349:
- Motorcultivator: 5,5 m/s
2
- Mower: 16,2 m/s
2
Data refers to maximum values recorded with
the range of engines available.
To Next Page
Loading...