TG 1000 – Digital Handheld Transmitter
32
3.6 Maintenance
• Protect the handheld transmitter from humidity, knocks and
shock. Avoid dropping the transmitter at all times.
• For cleaning metal surfaces, use a soft cloth moistened with
methylated spirits or alcohol.
• As soon as your microphone sounds dull, you should clean the
integrated pop shield. Proceed as described in the following.
– Unscrew the microphone grille anti-clockwise.
– Pull out the foam pop shield, if necessary use tweezers and
clean it under clear running water.
– If necessary, use a mild washing-up liquid.
– Dry it afterwards with a hairdryer or allow it to dry overnight.
– Clean the microphone grille both inside and out with a slightly
moistened cloth or a soft brush under clear running water
and allow it to dry overnight.
– The microphone grille cannot be cleaned in a dishwasher.
– Place the dry pop shield inside the microphone grille and
replace the microphone grille by screwing it on clockwise.
– With the TG V90w loosen the screws with a small screw-
driver and turn the upper part of the microphone head
anti-clockwise to unscrew it.
– Clean the upper grille under clear running water.
– Allow the upper grille to dry overnight before you replace it.
– The upper grille cannot be cleaned in a dishwasher.
–TheTG V96w is provided with a mesh pop shield.
– For cleaning turn the microphone grille anti-clockwise to
unscrew.
– Turn the wire mesh pop shield anti-clockwise to unscrew.
– Clean the pop shield under clear running water.
– Allow the pop shield to dry overnight before you replace it.
– The wire mesh pop shield cannot be cleaned in a dishwasher.
– Clean the microphone grille inside and outside with a slightly
moistened cloth or a soft brush under clear running water and
allow it to dry overnight.
– The microphone grille cannot be cleaned in a dishwasher.
TG V90w
TG V96w
To Next Page
Loading...
