Beyerdynamic TG 1000 - Display Brightness Adjustment; Factory Reset Procedure; Firmware and Region Code Display

TG 1000 – Digital Diversity Receiver
22
2.8.3 How to Set the Brightness of the Display
• In order to set the brightness of the display of the receiver, press
the function button . Select the “Display Brightness” submenu
by turning the rotary switch . Press the rotary switch  to
access the submenu.
• Turn the rotary switch  to select the desired brightness. In order
to confirm press the rotary switch . If you do not set the display
to minimum brightness, the display is dimmed after a certain
time.
• Warning: When the maximum brightness has been selected,
after a longer time a burning-in of the display is caused due to the
design. In order to ensure a long lifetime of the display, we
recommend selecting the setting as bright as needed and as dark
as possible.
▲ Network
• Display Brightness
▼ Factory Reset
f
Select the “Display Brightness” submenu
Select the “Factory Reset” submenu
Select the “Version Info” submenu
Display the Firmware Version and the Region Code
Restore default settings: yes or no
• Adjust Brightness
f
Set the brightness of the receiver display
2.8.4 Factory Reset
• For a factory reset press the function button . Select the
“Factory Reset” sub-menu by turning the rotary switch . Press
the rotary switch  to access the sub-menu.
• Turn the rotary switch  to select, if you want to reset the factory
or standard settings or not. Press the rotary switch  to confirm.
▲ Display Brightness
• Factory Reset
▼ Tx Firmware Upgrader
• Restore Defaults: Yes ODER No
f
f
Yes
No
2.8.5 How to Display the Version and Region Code
• In order to display the version and region code press the function
button . Select the “Version Info” sub-menu by turning the
rotary switch . Press the rotary switch  to access the sub-
menu.
• Here you can read the current firmware version of the receiver
and the used transmitters.
Important: The transmitters must be switched on.
• With the Region Code you can recognise which predefined
frequency ranges are provided for which regions in the TG 1000
system:
– Region Code: A 470 - 789 MHz
– Region Code: B 470 - 698 MHz
(without 608 - 614 MHz / US TV channel 37)
– Region Code: C 520 - 694 MHz
– Region Code: D 470 - 628 MHz & 710 - 716 MHz
– Region Code: E 470 - 714 MHz
Note: The Region Code is subject to changes!
▲ Tx Firmware Upgrader
• Version Info
MCU: Dev-01.09.25 RF: 1.0
DSP 1.9
Tx: Ch.1: 0.0 Ch.2: 0.0
Region Code: A
f
f