BL-E30-0515 - 03-01-2018 6-1
SECTION 6
BRAKE SERVICING
6-1. BRAKES.
The brake system consists of a transmission mounted
brake. This brake is spring applied and electrically
released.
6-1.1. Brake Assembly Replacement
1. Block load wheels.
2. Remove the lower compartment covers as
described in paragraph 5-3.
3. Disconnect electric brake from harness (3, Figure
12-20 or Figure 12-21).
4. Remove the three mounting screws (9, Figure 6-
1) and the brake.
5. Place the new brake into position and secure with
the three mounting screws.
6. Reconnect electric brake to harness (3, Figure
12-20 or Figure 12-21).
7. Remove load wheel blocks and check operation.
8. Install the lower compartment covers as
described in paragraph 5-3.
To Next Page
Loading...
