F.ACCE
Defines the terminal operating mode on
switch-on.
AUTOZ
The terminal executes autozero when
switched on. The terminal sets the weight to
zero when powered, following the instructions
taken from the CAMPAZ parameter (See
metrological parameter Personalization
Chapter in the installation manual).
ZERCAM
When switched on, the terminal executes the
calibrated zero, i.e. the instrument shows the
value of the weight on the scale in relation to
the value of the zero programmed during
calibration.
TBLOC
Defines the management mode of the tare at
the time the scale is unloaded.
YES
Any set or acquired tare values remain stored
even when the scale is empty and the gross
weight = 0.
NO
Any set or acquired tare values are
automatically deleted when the instrument
returns to zero, i.e. gross weight = 0.
SEPDEC DOT, COMMA
Selects the dot or comma as decimal
separator of the weight in the serial string.
LINIMES ITAL, ENGL, FRAN, DEUT, ESPA, PORT
Selects the language in which the terminal
operates.
D70
1-82
To Next Page
