Binder FP 53 - 17 Disposal; Disposal of the Transport Packing; Decommissioning

FP (E1.1) 07/2017 page 67/90
17. Disposal
17.1 Disposal of the transport packing
Packing element
Material
Disposal
Straps to fix packing on pallet
Plastic
Plastic recycling
Wooden transport box (option)
with metal screws
Non-wood (compressed
matchwood, IPPC standard)
Wood recycling
Metal
Metal recycling
Pallet (from size 115 on)
with foamed plastic stuffing
Solid wood (IPPC standard)
Wood recycling
PE foam
Plastic recycling
Transport box
with metal clamps
Cardboard
Paper recycling
Metal
Metal recycling
Top cover (size 720 only)
Cardboard
Paper recycling
Removal aid (sizes
240 and 400 only)
Cardboard Paper recycling
Plastic Plastic recycling
Edge protection
Styropor
®
or PE foam
Plastic recycling
Protection of doors and racks
PE foam
Plastic recycling
Bag for operating manual
PE foil
Plastic recycling
Insulating air cushion foil (packing of
optional accessories)
PE foil Plastic recycling
If recycling is impossible, all packing parts can also be disposed of with normal waste.
17.2 Decommissioning
Turn off the main power switch (1) and disconnect the chamber from the power supply (pull the power
plug).
When turning off the main power switch ON / OFF (1), the stored parameters remain saved.
• With option inert gas connection (chap. 15.8): Close the inert gas supply and remove the gas
connection.
WARNING
High concentration of inert gas.
Risk of death by suffocation.
 Respect the relevant regulations for handling these gases.
 When decommissioning the chamber, turn off the inert gas supply.
• Temporal decommissioning: See indications for appropriate storage, chap. 3.3.
• Final decommissioning: Dispose of the chamber as described in chap. 17.3 to 17.5.