BIO-MED DEVICES CROSSVENT-3+ - II- Unpacking and Accessories; A- Unpacking; B- Accessories

8
88
8
II- UNPACKING AND ACCESSORIES
A
AA
A-
--
- UNPACKING
UNPACKING UNPACKING
UNPACKING
CAUTION: Prior to turning the unit on for the first time, the battery must be charged fully
using the included power supply.
Examine the CROSSVENT carton to ascertain whether it has sustained any damage during shipment.
Inspect the contents of the shipping carton. If any damage to the product is observed, notify the carrier at
once. Only you, the consignee, can make a claim against the carrier for damage in shipment..
Once the Crossvent and accessories have been removed from the packaging and passed visual inspection,
place the unit in a location where it will be within reach of a standard AC outlet. Plug the separate AC
power cord into the accompanying power supply and then plug this cord into the standard AC outlet. Plug
the locking connector from the power supply, red dot facing to the front of the Crossvent, into the Power
Connector on the left side of the unit just below the ON/OFF switch. Once plugged in, the charging LED
above will begin to blink slowly (approximately once per second) indicating it is charging. (Rapid blinking
indicates a problem with the charging and Technical Support should be contacted at 800-224-6633).
Charge the unit until the green charging indicator stops blinking and remains solidly lit. This indicates the
battery is fully charged. This may take up to five hours depending on the state of the battery when the unit
was received.
Refer to the performance checks in the service section of this manual prior to placing this ventilator into
service.
B
BB
B-
--
- ACCESSORIES
ACCESSORIES ACCESSORIES
ACCESSORIES
The following is a list of the equipment supplied with the CROSSVENT-3+ Intensive Care/Transport
Ventilator. Additional accessories available for the Crossvent may be found on our website at
www.biomeddevices.com.
Quantity.
Cat. No. Description
1 3300C CROSSVENT-3+ Ventilator
1 2002K
1
Air/Oxygen Blender
1 2013 Pole Mounting Bracket
1 1010 High Pressure Supply Hose – Oxygen
1 PFIT150
2
DISS Male to Male Coupler
1 1011
2
High Pressure Supply Hose - Air
1 80011 Disposable Adult Breathing Circuit
1 1020 Test Lung
1 4401 Disposable Patient Filter
1 4410
1
Disposable Pediatric/Adult Pneumotach
1 4434 Oxygen Sensor Cell w/2.5mm Plug
1 4418 Oxygen Sensor Cell Tee
1 4414
1
Oxygen Filter/Water Trap
1 4415
3
Air Filter/Water Trap
1 3304C Instruction Manual
2120
2
Blender Instruction Manual
1 -------- Warranty Card
1 4419A Charger w/Cord, U.S.A. AC Adapter
1 4419B
3
Charger w/Cord, International AC Adapter
NOTE: 1 - OPTIONAL
2 - STANDARD WITH BLENDER
3
- STANDARD WITH INTERNATIONAL ORDERS