VII. CLEANING, STERILIZATION AND PACKING- cont.
33
3333
33
B
BB
B-
--
- PACKING FOR SHIPMEN
PACKING FOR SHIPMEN PACKING FOR SHIPMEN
PACKING FOR SHIPMENT
TT
T
In the event the CROSSVENT must be returned to the factory, it is very important to pack the unit
properly. The following is the correct packing procedure to insure safe transport:
Packing Materials Required:
Double Wall Carton
Suitable Shock Absorber - Foam or Air Bubble Wrap
Poly Bag
For the safety of all concerned, please thoroughly clean and disinfect the unit prior to packing
. If the unit is
being returned for service, please include all information relative to its need for service as well as the name
and phone number of the person we may contact regarding return.
If the unit you are returning is one that you received for evaluation, then all the accessories that came with
the unit must also be returned as outlined here.
Procedure:
1. Cover CROSSVENT with the poly bag and secure with twist tie or tape.
2. Wrap the CROSSVENT in the foam or bubble wrap, with at least 2 inches of material on all sides, and
place it into the carton.
3. Wrap oxygen sensor and any other adapters with bubble wrap (if returned).
4. Thoroughly wrap the power supply and power cord with bubble wrap and place it into the carton, making
certain that it cannot damage the CROSSVENT while in transit.
5. Place the gas supply hose, if returned, between the rear of the CROSSVENT and the carton wall.
6. Place the patient circuits and instruction manual in an orderly fashion into the remaining space (if
returned).
7. Fill the carton on all sides with packing material to prevent the unit from shifting during transit.
8. Close the carton with tape, noting serial number on the outside of the carton.
9. Ship to:
BIO-MED DEVICES, INC.
61 Soundview Road
Guilford, CT 06437 USA
To Next Page
Loading...
