APPENDIX A:
ATOMLAB DOSE CALIBRATOR TROUBLE-SHOOTING
PROCEDURES
OVERVIEW
Should it appear that your Atomlab Dose Calibrator is not
functioning properly, the procedures explained in this
appendix, and on the Quick Reference Chart provided with
this manual, should allow you to determine whether a
problem does indeed exist and what steps can be taken to
correct the difficulty.
Should you encounter any of the problems discussed in the
following sections, immediately perform the accompanying
steps to ascertain whether your dose calibrator requires
servicing. If you conclude that it does, contact the Biodex
Customer Service Department at 1-800-224-6339 for further
instructions.
This appendix assumes that you have performed all the
basic installation procedures presented in Chapter 2.
PROBLEM DESCRIPTIONS
The following problems are described in this appendix.
• System will not Power Up
• Fluctuations in Activity Measurement
• Unexpected Readings
• Determining the current Software Version
• Display Unit Fuse Inspection and Replacement
• Setting Up the Atomlab to accept 100 VAC or 240 VAC
• Important Notes about System Errors
SYSTEM WILL NOT POWER UP
If your Atomlab Dose Calibrator fails to power up, perform
the following steps, proceeding to the next step only if the
current one fails to remedy the problem:
ATOMLAB Dose Calibrator Operation Manual Appendix A
Biodex Medical Systems A-1 Release 2.0
To Next Page
Loading...